Design Your Custom Non-Slip Strip

You don't need to log in or register to use the Virtual Proof software.  After this page loads, follow these instructions to Place Artwork: http://www.technologo.com/sku.asp?sku=egrips

1. Click "Full eGrip" tab to expand artwork section.

2. Click "Place art".

3. Click "Green + Upload art to this folder" link ... no need to log-in | register.

4. Click "Upload Art without saving it in a portfolio" … will only do this once.

5. Click Browse to find your art file, give it a Name, then click the Upload link.

6. Click “Green + Place Art”, art will show on the egrip, begin designing and editing.

Click here to launch software in a new window ... may need to check Pop-Up blocker

Forget Password?    Contact Technologo Support:  877-541-5646, ext 227 or This e-mail address is being protected from spambots. You need JavaScript enabled to view it

Contact Matt Malone if you cannot get a hold of Technologo support.